CM MACCHINE
1 SIDE BRUSHING MACHINE
-MODEL ROS 600-4 -
CM Macchine's ROS 600-4 1-side BRUSHING MACHINE is an easy-to-use machine suitable for wood carpentry, sawmill, carpentry.
This machine has the particularity of being equipped with special abrasive brushes that deform the treated surface, giving the wood a particular "sandblasting effect Different brushes can be mounted according to the type of finish required. Quick brush replacement system.
The machine is equipped with a protective cabin and complete with electrical panel and wiring.
The machine is equipped with a protective cabin and complete with electrical panel and wiring.
The maximum width of the workpiece is 600 mm.
ROS 600 4 - ENG
Send download link to:
ROS 600-4
MODEL COMPOSITION
MACHINE STRUCTURE
The abundantly sized iron supporting structure is made up of high-strength structural tubular elements.
The machine is equipped with a variable speed feeding belt, upper groups with independent height movement.
CM Macchine's ROS 600-4 brushing machine is made up of 4 independent synthetic abrasive brushes with a diameter of 250 mm and a width of 650 mm which deform the treated surface.
BRUSHES HOLDER CARRIAGE
There is a mobile brushes holder carriage on two rectified columns, with up/down movement controlled by an electric motor.
PRESSURE ROLLERS
There are pressure rollers for each brushing unit for perfect adherence between the material to be treated and the feeding belt.
ELECTRIC MOTOR
The electric motor is of high power for the rotation of each brush.
FEEDING BELT
The feeding belt is made of a special synthetic material with a high adherence coefficient and is equipped with speed regulation. The advancement and towing of the belt are controlled by a speed reducer, with the possibility of feeding from both sides (optional).
THE PHASES IN DETAIL
WORKING PROCESS
The working process of the ROS 600-4 1-side BRUSHING MACHINE consists of three phases:
1. The workpiece is placed on the conveyor belt and pushed over the loading surface.
2. The conveyor belt drags the piece up to the brushes, where these remove the soft fiber from the surface being worked, leaving the veins and the more resistant fibers in relief.
3. Finally, the piece comes out of the machine and is supported by hand.
Technical data | ||
Maximum workpiece height | mm | 500 |
Maximum workpiece width | mm | 600 |
Minimum workpiece length | mm | 450 |
Electronically variable feed speed | m/min | da 4 a 16 |
Machine length | mm | 3200 |
Machine width | mm | 1600 |
Machine height | mm | 1800 |
Total machine weight | kg | 1550 |
CM MACCHINE
