CM MACCHINE
3 SIDES BRUSHING MACHINE
-MODEL BIG 20-6 RUSTIFLEX -
CM Macchine's BIG 20-6 brushing machine was born from the company's long experience in the woodworking. With this type of brushing machines we offer you innovative and unique solutions in terms of flexibility and practicality of use, as well as the structural solidity typical of the machines produced by CM Macchine.
This machine has the particularity of being able to work the products on 3 sides at the same time, i.e. beams, boards, matchboards and wooden floors. An extra touch is given by the special abrasive brushes which have the power to deform the treated surface with the particularity of giving a rustic effect to the edges of the boards. Depending on your needs, it is possible to find different sizes of abrasive brushes, in this case brushes have Ø190 mm.
Finally, there is the possibility of converting the brushing machine into a sanding machine in order to be able to clean the output beams of a work center or yellowed after storage.
This machine has the particularity of giving a rustic effect to the edges of the boards.
BIG 20-6 RUSTIFLEX - ENG
Send download link to:
COMPOSITION MODEL BIG 20-6 RUSTIFLEX
MACHINE STRUCTURE
CM Macchine's brushing machines are equipped with special large diameter abrasive brushes which deform the treated surface, giving the wood a particular "sandblasting effect". As regards, in the BIG 20-6 machine, the brushes have a diameter of 190 mm.
The BIG 20-6 machine can work a piece of height mx. 600 mm and a max. 400mm.
THE PHASES IN DETAIL
WORKING PROCESS
The working process of the 3-sides brushing machine BIG 20-6 RUSTIFLEX consists of three phases:
1. The workpiece is placed over the incoming idle rollers and pushed into the machine.
2. The rubber-coated rollers drag it towards the brushing units, where the brushes remove the soft fiber from the surface being worked, leaving the veins and the more resistant fibers in relief.
3. Finally, the piece comes out of the machine and is supported by hand or made to slide on a roller conveyor.
Technical data | ||
Maximum workpiece height | mm | 600 |
Maximum workpiece width | mm | 400 |
Minimum workpiece length | mm | 800 |
Electronically variable feed speed | m/min | from 4 to 16 |
Machine length | mm | 2100 |
Machine width | mm | 2300 |
Machine height | mm | 2050 |
Total machine weight | kg | 2300 |
CM MACCHINE
